About Burner Ignition
Each knob has an associated burner, the location of which appears next to the knob.
NOTE
•
The flame should burn evenly around the burner, except below each grate support,
where flame height is reduced by Dacor's Smart Flame feature. A normal flame is
steady and blue. Foreign matter in the gas line, especially in new construction, may
cause an orange color that disappears with use. Yellow-tipped flames are normal
for LP gas. If a burner does not ignite, or the igniter keeps sparking, or the flame is
uneven, see Troubleshooting, Pg. 99.
The igniter sparks if the flame is affected by a draft or home ventilation. Eliminate
•
drafts and reduce the ventilation blower speed to minimize this condition.
If no spark is produced, verify that electricity is available. If there is a power failure,
•
see Manual Ignition (below).
Food cooks as quickly at a gentle boil as it does at a rolling boil, which wastes
•
energy and cooks moisture, flavor and nutrients out of food.
Use a low/medium flame for cookware that conducts heat poorly (e.g., glass,
•
ceramic, cast iron). Lower the flame until it covers about 1/3 of the cookware
diameter to ensure even heating and minimize scorching.
Manual Ignition
During a power failure, you can ignite the burner manually. Use caution when doing
this.
1. Hold a long gas grill lighter to the surface burner you want to light.
2. Push in the control knob for that burner and then turn it to the flame symbol position.
Turn on the grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame level.
FULL_DOP36C86DLSDA_DG68-01507A-00_EN+MES+CFR.indb 31
FULL_DOP36C86DLSDA_DG68-01507A-00_EN+MES+CFR.indb 31
OFF
To light a burner:
1. Push in the knob and turn it
counterclockwise to the flame symbol.
The igniter sparks and clicks until the
burner lights (about 4 seconds).
2. Place the cookware on the grate.
3. Adjust the flame as needed for proper
cooking.
English 31
2023-02-23 오후 5:08:57
2023-02-23 오후 5:08:57