Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
3-3 Operation
DANGER
Risk of crushing and cutting!
Check that the tool has been disconnected from the
compressed air supply. An untimely triggering of the
setting or screwing cycle (Push-Pull system) may
cause injuries.
WARNING
Injury risk!
Working with the tool entails potential risks. Always
wear safety goggles, protective gloves, close-fitting
work clothes, and safety boots.
Aim and utility of the tool:
The RIVKLE
®
NEO P107 tool is intended for setting
RIVKLE
®
blind rivet nuts & studs into pre-drilled
materials.
It is intended for all types of industries and applications
in which the creation of a thread in a thin sheet is
required. This tool has force setting technology which
guarantees the setting and increases repeatability. It
has a tool-free replacement system for mandrels and
allows for simple use without the need for specific skills.
Advantages
n
Consistent setting force even for materials with
varying thicknesses
n
Does not damage the RIVKLE
double setting
n
Allows for quality control
(Optional RIVKLE
®
FC340 force indicator)
n
Optimises the life span of the mandrel
Principle of force setting:
ATTENTION
The adjustment of the force valve is an operation
that must be carried out by qualified and trained
personel. Inappropriate adjustments risks downgrading
the mechanical performances of the Blind rivet nut
after setting, or may damage the tool and potentially
the application.
Unlike the principle of Stroke setting, in which the
movement distance of the mandrel (stroke) is manually
adjusted using a mechanical stop, force setting
requires the adjustment of the setting force (F) of the
tool in line with the technical characteristics of the
blind rivet nut.
®
in the event of
The setting force is indicated in the RIVKLE
catalogues, don't hesitate to contact your local
Böllhoff representative for any questions regarding
the setting force to be applied to products from the
RIVKLE
®
range.
When the previouisly adjusted force has been
reached, the tool stops crimping automatically
and moves onto the unscrewing phase.
The setting force generated by the RIVKLE
P107 machine ranges from 3 to 18 kN.
Implementing a blind rivet nut with the RIVKLE
P107 tool:
A - Please refer to the Böllhoff blind rivet nut catalogue
or contact an official Böllhoff representative to
determine the setting force required to set your
blind rivet nut.
B - Adjust the setting force on the RIVKLE
P107 tool adjustment valve (Chap. 3-4).
C - Set your blind rivet nut, the RIVKLE
tool applies the setting force previously set.
EN
®
®
NEO
®
NEO
®
NEO
®
NEO P107
39
Publicidad
