Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
ISSUE
UNSCREWING
The tool continuously
unscrews
The tool doesn't unscrew
at the end of the setting
stroke.
(Use the manual unscrewing
procedure - Paragraph 6.3)
The tool takes time to
unscrew after the end
of the setting process
SETTING COMPLETED
Blind rivet nut tapping
damaged after its
installation
After setting the blind rivet
nut get loose in the
application
PROBABLE CAUSES
Internal fault
1- Insufficient compressed air
pressure.
2- Lack of oil.
3- Faulty pneumatic motor.
4- Setting force too high.
5- tool isn't held in place in the
setting axis during unscrewing
1- Lack of oil
2- The setting force is excessive
3- Insufficient compressed air
pressure
1- Mandrel thread damaged, worn
2- The blind rivet nut isn't in
contact with the anvil
3- Setting force too high
4- Perpendicularity with the
application not respected
5- Application thickness
incompatible with the
blind rivet nut
1- Setting force too low
2- The blind rivet nut isn't in
contact with the anvil
3- Application thickness
incompatible with the
blind rivet nut
4- The punch diameter or the
drill diameter of the application
is not subject to Böllhoff
recommendations.
SOLUTIONS
Contact a Böllhoff-certified repair centre or your maintenance
service, if they've completed Böllhoff-certified training.
1- Check the service pressure (Paragraph 5.5)
2- Top up the oil using the filling bottle provided
(Paragraph 8.4)
3- Disconnect the compressed air supply, then check
the motor by turning the mandrel
4- Check the setting force in the RIVKLE
Check the setting force set on the tool (Paragraph 5.4) /
Check the setting force of the tool using the RIVKLE
FC340 force indicator / Increase the frequency of this
check
5- Hold the tool in the setting axis during unscrewing
1- Top up the oil using the filling bottle supplied
(Paragraph 8.4)
2- Check the setting force in the RIVKLE
Check the setting force set on the tool (Paragraph 5.4) /
Check the tool's traction force using the RIVKLE
force indicator /Increase the frequency of this check
3- Check the service pressure (See Paragraph 5.5)
1- Change the mandrel, Increase the replacement frequency
(Paragraph 5.2)
2- Set the position of the anvil following the instructions
(Paragraph 5.3)
3- Check the setting force required for installing your blind
rivet nut in the RIVKLE
®
catalogue / Check the setting
force set on the tool (Paragraph 5.4) / Check the setting
force of the tool using the RIVKLE
Increase the check frequency
4- Throughout the blind rivet nut installation phase,
take care to keep the tool and the application
perpendicular to one another (Paragraph 6.2)
5- Check that the thickness of your application is
compatible with the blind rivet nut, refer to the Böllhoff
recommendations.
1- Check the setting force in the RIVKLE
Check the setting force set on the tool (Paragraph 5.4) /
Check the setting force of the tool using the RIVKLE
FC340 force indicator.
Increase the frequency of this check
2- Adjust the position of the anvil (Paragraph 5.3).
3- Check that the thickness of your application is
compatible with the blind rivet nut, refer to the Böllhoff
recommendations.
4- Check that the drill or punch dimensions are compliant
with Böllhoff recommendations.
EN
®
catalogue /
®
®
catalogue /
®
FC340
®
FC340 force indicator /
®
catalogue /
®
54
Publicidad
