Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
Pneumatic supply
n
Do not exceed the maximum pneumatic
pressure indicated on the tool: 6.5 bar - 94 psi.
n
The pressurised air may cause serious injury:
- Always disconnect the tool from the compressed
air supply when it is not in use or during adjustment
and accessory change operations.
- Never direct their air flow towards yourself or
someone else.
- Always check that the connection pipes are
properly secured and in good condition.
- Keep hands and arms away from the air outlet
holes.
- Never move the tool by holding it by its pneumatic
supply hose.
n
For proper functioning, check that the air
inlet and outlet are clean and correctly
connected before use. The use and a filter/
regulator/lubricator on the installation is required
to guarantee the proper functioning of the tool,
in compliance with the guarantee conditions.
n
Do not obstruct or cover the air outlets.
4-4 Risks associated with using the tool
The tool must only be used:
n
Within the context of the use for which it has been
designed,
n
in perfect operational condition,
n
fully informed of the safety recommendations and
risks entailed.
Do not use the tool if you notice any malfunction
which compromise safety.
DANGER
Risk of part projection!
If a part, accessory or the tool itself breaks, this may
cause high-speed projectiles or sudden shocks on
the tool handle. Carry out all necessary verifications
defined in this user manual before using the tool.
Check:
n
Misalignment or entrapment of moving parts.
n
Broken or damaged parts, visible signs of impact
or cracks.
n
Abnormal action or parts which move apart/together.
n
Oil leak, marks, sweating.
DANGER
Risk of pressurised oil projection!
Never use the tool at a service pressure above 6,5
bar (94 psi). Using the tool at a service pressure in
excess of 7 bar (101 psi) may cause structural parts
to rupture, generating high-speed projectiles or
pressurised oil splashes.
DANGER
Crush risk!
Never remove the nose when the tool is connected
to the compressed air supply. Maintenance or r
eplacement operations for the mandrel and anvil
adjustment operations must be done when the tool
is disconnected from the compressed air supply
(with the exception of the "Adjusting the screwing
trigger (Push-Pull system)" operation, described in
Paragraph 8.5).
During the screwing operations (push-pull system),
screwing the RIVKLE
®
RIVKLE
®
must be held at its end by the fingertips.
Do not put your fingers between the head of the
RIVKLE
®
and the anvil. It is imperative that you
wear appropriate gloves.
DANGER
Cut risk!
Never activate the Push-Pull screwing system
without a RIVKLE
®
assembled on the mandrel with
your fingers or your hands, even if wearing gloves.
Be careful at all times not to inadvertently activate
the Push-Pull screwing system.
WARNING
Drop risk!
Connection elements not tided away or incorrect
posture pose a tripping risk.
n
Make sure that the environment in which the tool
is used is kept clean and tidy.
n
Make sure that you are stable and well-balanced
when using the tool.
Be prepared to counter the weight of any
n
movements of the tool or of the part you are going
to set the RIVKLE
®
into.
DANGER
Injury risk !
Fatigue or excessive efforts caused by repetitive mo-
vements in poor posture may result in injury.
n
Make sure you maintain a comfortable and stable
position when using the tool.
n
Make sure you change positions when working
for prolonged periods.
onto the mandrel, the
EN
45
Publicidad
