Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
8. Maintenance
PLEASE NOTE
The various maintenance operations depend on the use of the tool. Contact a Böllhoff legal representative
to assess the maintenance operations to be carried out.
8-1 Safety guidelines regarding maintenance and repair
WARNING
Tool maintenance must be entrusted to individuals who have receive the appropriate training from a
Böllhoff-certified technician.
Given the hydraulic pressure generated by the tool, risks of potential injury caused by inappropriate mainten-
ance operations carried out by unqualified individuals. Any maintenance operation not authorised by Böllhoff
during the guarantee period will automatically invalidate this guarantee.
DANGER
The pneumatic supply must be disconnected from the compressed air supply prior to any maintenance
or repair operations.
WARNING
Injury risk !
Working with the tool entails potential risks. Always wear safety goggles, protective gloves, close-fitting work
clothes, hearing protection and safety boots.
8-2 Daily/weekly maintenance
Grease the mandrel.
Check that there are no leaks in the pneumatic hose,
pneumatic connectors or surface of the tool.
Check that there are no unusual movements between its
various mechanical and structural parts whilst the tool is
in use (e.g. between the body and the tank).
Check that there are no unusual noises whilst the tool is
operating, other than those inherent to its use (e.g. cracks,
friction noises, etc.).
If you detect a hydraulic leak, stop using the tool
immediately.
Check that the tool hasn't been dropped, carrying out
a visual check for any marks or knocks on its surface.
Check that the nose and anvil (and any adapter parts)
assembled onto the tool are compatible with your blind rivet
nut, and check that they're properly adjusted.
OPERATION
FREQUENCY
• Once daily
• For each job start
• Once daily
• For each job start
• After maintenance
• After the tool has been dropped
• After using an unauthorised service pressure
• After the application of excessive force
• Once daily
• For each job start
• After maintenance
• After the tool has been dropped
• After using an unauthorised service pressure
• After the application of excessive force
• Once daily
• For each job start
• After maintenance
• For each job start,
• After maintenance,
• Each time the mandrel and anvil are changed
• Each time after the mandrel and anvil are greased
EN
56
Publicidad
