Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
Standard CHC screw (Not included with the tool)
A
B
C
D
Disconnect the compressed air tool
1- Greasing the standard screw (E2) along its smooth
part up to the underside of the head, do not apply
grease to the thread (Böllhoff recommends using
MOS2 grease).
2- Assemble the adapter (E1) onto the standard
screw (E2), and the widest side of the adapter must
be placed underneath the screw head. Grease the
external surface of the adapter.
Blind rivet nut
FULL CHC KIT
Spare parts for the CHC Kit
E1
Adapter
Set of 10 standard
E2
CHC screws*
E3
Hexagonal drive shaft
* ISO 4762 DIN 912
E1
E2
E3
G
F
23650000001 23650000002 23650000003 23650000004 23650000005
23659900009 23659900008 23659900007 23659900006 23659900005
M3x60MM
23680303020
23659900013
3- Grease the hexagonal end piece of the hexagonal
drive shaft (E3) and apply it up over the head of the
standard screw (E2).
4- Insert the standard screw (E2) + adapter (E1) +
hexagonal drive shaft (E3) into the traction bush (D),
check that the elements are securely in place.
5- While holding the elements securely in place,
tighten by hand on the tool's piston (F) until it reaches
a stop. Take care to make sure that you cover the
O-ring of the Push-Pull adjustment bush (G).
6- Screw the nose (C) onto the body of the tool using
a 21 mm spanner, applying a 10 Nm torque. Screw
the anvil (A) + locknut (B) assembly onto the nose (C).
Connect the tool to the compressed air,
and the drive shaft will pair up with the
standard screw (E2) automatically.
M3
M4
M3
M4
M4x60MM
23680304020
23680305020
23659900012
23659900011
M5
M6
M5
M6
M5x65MM
M6x65MM
23680306020
23659900010
EN
M8
M8
M8x70MM
23680308020
23659900002
48
Publicidad
