Publicidad
Idiomas disponibles
Idiomas disponibles
RIVKLE
®
NEO P107 - Instruction manual
Repair kit reference 23617291001
This repair kit contains the following components:
n
Pneumatic and hydraulic seals
Drive shaft
n
n
Trigger
n
Traction bush
n
Silencer pads
n
Screws
n
Adjustment bushing group (Push-Pull system)
n
Push-Pull group
n
Bleed screw group
n
Force valve group
n
Trigger valve group
n
Booster valve group
n
Manual unscrewing valve group
n
Hydraulic plunger group
Special tool kit reference 23617290001
This tool kit may only be sold after training delivered by
an organisation certified by Böllhoff. Please contact a
Böllhoff representative for further information.
8-4 Oil check/top-up
An insufficient oil level may cause malfunctions,
and so it is important to follow this operating
procedure.
PLEASE NOTE
We recommend checking the oil level of your tool
once weekly, using the procedure described below
for help.
DANGER
Risk of pressurised oil projection!
Check that the tool is disconnected from the
compressed air supply before unscrewing the bleed
screw. An untimely triggering of the setting cycle
may cause pressurised oil projection and may cause
serious injury. Even when there is no air supply, a
residual pressure may persist and cause oil release.
Please only use mineral oil with a viscosity
grade of 68. The oil must be clean and free
from particles, and must not contain silicone
(Reference Böllhoff 29140000001/00 – 1 Litre).
1
Unscrew the bleed
screw using the 4 mm
hexagonal key
supplied.
!
0 bar/psi
2
The minimum oil level
is located just above
the bottom of
the hole.
3
Check imperatively that the oil
level in the oil filling bottle does
not exceed the maximum
level indicated.
Empty oil filling bottle: 23650000007
4
Screw the oil filling bottle
provided, which should
contain mineral oil with
a viscosity grade of 68.
Check for the
presence of the
seal washer on the
oil filling bottle.
5
Press and hold down
the trigger for 3 seconds,
and watch the air
bubbles rise up in
the oil filling bottle.
Repeat this operation
3 times.
3 sec.
6
Re-screw the bleed screw and its seal washer,
run 3 "in air" cycles to get the oil moving through
the hydraulic circuit, if the tool automatically
unscrews, the oil top-up is complete. If the tool
doesn't unscrew automatically, restart the
procedure from step 3. If the tool still isn't
unscrewing automatically after three attempts
of topping up the oil, please contact
a Böllhoff-certified repair centre.
4 mm
MINI
3x
EN
58
Publicidad
