Angelo Po BX61G Manual De Uso página 35

INSTRUCTIONS AND WARNINGS FOR USE
Important
Besides being authorised and appropriately documented,and if necessary,instructed and
trained, users,on fi rst usage, have to simulate several operations to identify the controls
and main functions.
Use only as intended by the manufacturer and never tamper with any device to obtain
performance levels outside the rated specifi cations.
Before use, check that the safety devices are properly installed and in good working or-
der.
As well as taking care to meet these requirements, users must also implement all safety
regulations and read the description of the controls and the start-up procedure carefully.
The manufacturer recommends using the oven above 250°C only when strictly necessary
and for short periods of time, not to reduce the life of your equipment.
DESCRIPTION OF CONTROLS
1) On-off button: for switching the appliance' on and off .
2) START-STOP button: Starts or ends the selected program cycle, shown on the display (coo-
king cycle, washing cycle, etc.).
Green light on (steady light): cooking program in pause status or ready to start.
Press the button to start the cooking program.
Green light on (fl ashing): cooking program in progress.
Green light off : appliance off .
3) Convection cooking button: for selecting convection (fan-assisted hot air) cooking mode.
Green light on: convection cooking mode selected.
4) Mixed cooking button: for selecting mixed cooking mode (convection + steam).
Green light on: mixed cooking mode selected.
5) Steam cooking mode button: for selecting steam cooking mode.
Green light on: steam cooking mode selected
6) Temperature setting button
– To set the cooking temperature: press once (the green light fl ashes) to set the temperature
using the knob (10).
– To modify the temperature during cooking: press once to display the value of the temperature
set on the display (11).
Press the button and turn the knob (10) to modify the value set.
– Changes the temperature unit of measurement from degrees Centigrade (°C) to degrees
Fahrenheit (°F).
With the appliance in the STOP phase (green light (2) on) press the button and hold it down for
longer than 3 seconds (the whole panel powers down).
Press and hold the button (6) and turn the knob (10) to select temperature display in ° C or ° F.
Press the knob (10) to confi rm the changes made.
7) Time setting button (Timer)
– To set the cooking time: press once (the green light fl ashes) to set the cooking time using the
knob (10).
Keep the button pressed for about 2 seconds to set an "unlimited" cooking time; the display
(12) shows the message "InF", which cannot be modifi ed.
– To modify the time during cooking: press once to display the value of the time set on the di-
splay (12).
Press the button and turn the knob (10) to modify the value set.
– Enable or disable the automatic preheating.
With the appliance in the STOP phase (green light (2) on) press the button and hold it down for
longer than 3 seconds (the whole panel powers down). Press and hold the button (7) and turn
the knob (10) to enable or disable the automatic preheating.
Press the button (7) to confi rm the changes made.
3338970_ut_GB
USE AND OPERATION
- 7 -
GB
ENGLISH