Angelo Po BX61G Manual De Uso página 41

LENGTHY DOWNTIMES OF APPLIANCE
If the appliance is to be out of use for a lengthy period, proceed as follows.
1) Turn off the gas supply tap.
2) Turn off the water supply tap.
3) Cut off the mains electricity supply using the appliance's master switch.
4) Clean the appliance and the surrounding areas thoroughly.
5) Spread a fi lm of edible oil over the stainless steel surfaces.
6) Carry out all the servicing procedures.
7) Cover the appliance and leave a few gaps to allow air to circulate.
INSTRUCTIONS AND WARNINGS FOR SERVICING
Keep the appliance at peak effi ciency by carrying out the scheduled servicing procedures
recommended by the manufacturer. Proper servicing will allow the best performance, a longer
working life and constant maintenance of safety requirements.
Caution - Warning
All maintenance work that requires precise, technical expertise or particular skills or qualifi -
cations for legal reasons,should be carried out by suitably trained and/or qualifi ed staff and
in any case with recognised experienced gained in the specifi c fi eld of intervention.
In particular, turn off the gas and water supply taps, cut off the electricity supply using
the master switch and prevent access to all devices that might cause unexpected health
and safety hazards if turned on.
At the end of each session of use and whenever necessary, clean:
– The condensation collection tank (see page 15);
– The cooking chamber (see page 15);
– The combustion air intake and check that it is not obstructed (see "installation manual")
– The appliance and the surrounding environment (see page 14).
Caution - Warning
At least once every 6 months or, if meat or greasy foods are cooked frequently, every 2
months clean the vent (see page 17) .
Every year, have skilled, authorised personnel carry out the following operations:
– A check on the gas pressure and system tightness
– A check on the effi ciency of the fl ues and air intakes, cleaning them if necessary.
– Check the tightness of the gaskets of the heat exchanger and replace them if necessary.
– Check that the ignition plugs are working properly (and replace them if necessary,
– see "installation manual") eand that the power supply cable is intact.
– Check the tightness of the seals of the ignition plugs , the inspection window and the
combustion air fan.
– Check the carbon monoxide (CO) and carbon dioxide (CO2) values in the exhaust gases.
– Cleaning of the water intake fi lter (see "installation manual").
– Cleaning of the drain lines (see "installation manual").
3338970_ut_GB
SERVICING
- 13 -
GB
ENGLISH