Klarstein MASTER JERKY 300 Manual Del Usuario página 27

PREPARATION
Note: It is important to monitor the dehydrating device during operation. Never
leave the dehydrator unattended. Read and understand all instructions and
warnings before using this appliance. Only use the appliance in well-ventilated
rooms. Do not block the ventilation openings on the back or door of the
dehydrating appliance.
1 Place the automatic dryer on a clean, dry surface.
2 Insert the plug into the socket.
3 Place the dryer at least 30.5 cm from a wall to ensure sufficient air circulation.
Do not block the ventilation openings on the back or on the door of the
dehydrator.
4 Remove the slots from the dehydrator. Load the trays with the products to
be dried. Position the individual parts so that they do not touch each other.
Do not overlap the food and do not let them touch you. Ensure that there is
sufficient clearance between the products to ensure sufficient air circulation.
Remove excess water from the food. (This can be done by dabbing the food
with a paper towel or napkin). Excess moisture can cause the temperature of
the dehydrating appliance to drop.
5 Set the operating switch to ON or TIME.
6 Set the temperature to the desired setting. It is recommended that you
insert an oven thermometer (not supplied) into the dryer to monitor the
temperature setting.
7 Set the timer button to the desired drying time.
8 Preheat the dryer for 5-10 minutes before sliding the grids into the dryer.
9 Water droplets may form on the surface of some products during drying.
These can be removed by dabbing the product with a clean towel or paper
towel. Be careful, the drying machine will get hot!
EN
27