Parking Brake Adjustment - Yamaha YFZ450T Manual Del Propietário

1. Locknut
A. Cable length
1. Contre-écrou
A. Longueur de câble
1. Contratuerca
A. Longitud del cable
1. Locknut
1. Contre-écrou
1. Contratuerca
2. Adjusting bolt
2. Boulon de réglage
2. Perno de ajuste
2. Adjusting nut
2. Écrou de réglage
2. Tuerca de ajuste

Parking brake adjustment

Parking brake adjustment may be required if the
parking brake does not hold properly. The cable
length A should be adjusted to 56–60 mm.
1. Loosen the locknut and the adjusting nut on
the brake cable below the fuel tank.
2. Fully loosen the locknut and the adjusting bolt
at the rear brake caliper.
3. Turn the adjusting nut on the brake cable in
direction a to increase the cable length or in
direction b to decrease the cable length.
NOTE:
_
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
_
4. Tighten the locknut on the brake cable.
8-93
EBU14160