Selecting Gaskets; Devices With A Wafer-Type Design - ABB ProcessMaster FEP300 Manual Del Usuario

4.1.2

Selecting gaskets

The following points must be observed when installing gaskets:
Devices with a hard rubber, soft rubber or ceramic carbide liner
• Devices with a hard / soft rubber liner always require additional gaskets
• ABB recommends using gaskets made from rubber or rubber-like sealing materials
• When selecting the gaskets, ensure that the tightening torques specified in chapter are not
exceeded
Devices with a PTFE, PFA or ETFE liner
• In principle, devices with a PTFE, PFA or ETFE liner do not require additional gaskets
4.1.3

Devices with a wafer-type design

For devices with a wafer-type design, ABB offers an installation set as an accessory that
comprises threaded rods, nuts, washers and centering sleeves for installation.
Fig. 6:
1 Threaded rod
2 Nut with washer
CI/FEX300/FEX500-X1
1 2 3
Installation set for wafer-type installation
FEX300, FEX500
3 Centering sleeves
Mounting
3
G01348
EN - 15