ABB ProcessMaster FEP300 Manual Del Usuario página 131

Parameter overview
7 Parameter overview
IMPORTANT (NOTE)
This overview of parameters shows all the menus and parameters available on the device. Depending on the version
and configuration of the device, not all of the menus and parameters may be visible on it.
1
Easy Setup
2
Device Info
italics = Parameter can only be changed at the "advanced" password level.
58 - EN
Language
Q (Flowrate) Unit
Qmax
Totalizer/Pulse Unit
Pulse Mode
Pulses per Unit
Pulse Width
Damping
Iout at Alarm
Low Alarm Value
High Alarm Value
System Zero
Cable length
Sensor
Acquisition
FEX300, FEX500
Manual
Automatic
Sensor Type
Sensor Model
Sensor Size
Qmax DN
Qmax
Qmax 2
Span Ss
Zero Sz
User Span
Mains Frequency
Excitation Freq.
Coil Current
Pre-Amp
Sensor ID
SAP / ERP No.
Term Board S/W
Sensor Run Hours
Calibration
Properties
Rate ADC
Analog Reset
Driver
First Cal. Date
Last Cal. Date
Cal. Cert. No.
First Cal. Location
Last Cal. Location
Cal. Mode
Cal. Status
Electrode Material
Lining Material
Noise Reset Max
Noise-Reset ON
Driver DAC
Loop Control Mode
Diff Current Control
Control Timer
CI/FEX300/FEX500-X1