4.3
Information on 3A conformity
IMPORTANT (NOTE)
If concentric reducers are installed on the device, it must be mounted in a vertical position.
Fig. 8
1 Bracket
Please observe the following points:
•
Do not install the device vertically with the terminal box or transmitter housing pointing
downward.
•
The "angle bracket" option no longer applies.
•
Please ensure that the leakage hole of the process connection is located at the deepest
point of the installed device.
•
Only devices with a transmitter with dual-compartment housing are 3A-compliant.
CI/FEX300/FEX500-X1
1
2 Leakage hole
FEX300, FEX500
Mounting
2
G01319
EN - 21