Device Start Up; Software Version; Language Selection; Starting Therapy - smith&nephew RENASYS GO 66801244 Manual De Instrucciones

Device start up

Device operates on both battery and AC mains power.
If battery operation is required for first use of device,
battery must be charged from AC mains power until
battery status top indicator light illuminates solid green.
During charging process the battery status top indicator
light will flash green.
If AC mains power is required, connect power supply to
the AC mains power inlet, on the side of device.
To activate device, press and hold Power
for 2 seconds. Device display will show:
If device is being used for the first time, the user will be
given the option to select desired language:

Software version

To access software version of a device:
1. Turn device off.
2. Press and hold Power
Device display will show:
3. The software version is provided on the lower right-
hand corner of the welcome display screen.
button
button for 2 seconds.
13

Language selection

To change language selection:
1. Turn device off.
2. Simultaneously press and hold
Up + Select + Power
seconds.
3. Language can now be selected using
Up and Down
language, followed by Select
4. Pressing Select button at this point will power
on the device at a preset 80mmHg in continuous
mode, if the device is being used for the first time,
or the previously entered pressure setting.

Starting therapy

1. Select prescribed pressure setting using
Up and Down
2. Press Select button to start therapy.
3. Finished dressings should be fully compressed,
firm to the touch and leak free.
Setting pressure level is a decision that the healthcare
provider must make based on an individual
assessment of the particular wound.
40–120mmHg is recommended therapeutic pressure
range.
In the event you have a wound that is difficult to seal,
you may increase the pressure setting to achieve
desired negative pressure at the wound bed.
Device will show set pressure level. If device detects
operation outside of the set pressure, it will result in
alarm activation.
Caution: Before starting therapy, ensure that device
and system tubing are located no more than 19 inches
or 50cm higher than the wound and is away from any
direct sources of heat.
EN
buttons for 2
buttons to scroll to desired
button.
buttons.