Siemens SINAMICS G120 Instrucciones De Servicio página 155

Conjunto Extended Speed Control with parameter assembly, número de instancia: 171, tipo: Input
Byte Bit 7
0 At
Reference
1 Drive State
2 Speed Actual (Low Byte)
3 Speed Actual (High Byte)
4 Data In 1 Value (Low Byte)
5 Data In 1 Value (High Byte)
6 Data In 2 Value (Low Byte)
7 Data In 2 Value (High Byte)
8 Data In 3 Value (Low Byte)
9 Data In 3 Value (High Byte)
10 Data In 4 Value (Low Byte)
11 Data In 4 Value (High Byte)
12 Data In 5 Value (Low Byte)
13 Data In 5 Value (High Byte)
14 Data In 6 Value (Low Byte)
15 Data In 6 Value (High Byte)
16 Data In 7 Value (Low Byte)
17 Data In 7 Value (High Byte)
18 Data In 8 Value (Low Byte)
19 Data In 8 Value (High Byte)
20 Data In 9 Value (Low Byte)
21 Data In 9 Value (High Byte)
22 Data In 10 Value (Low Byte)
23 Data In 10 Value (High Byte)
Conjunto Basic Speed and Torque Control, número de instancia: 22, tipo: Output
Byte Bit 7
0
1
Speed Reference (Low Byte)
3 Speed Reference (High Byte)
4 Torque Reference (High Byte)
5 Torque Reference (High Byte)
Convertidores con las Control Units CU250S-2 (vectorial)
Instrucciones de servicio, 06/2013, FW V4.6, A5E31759476E AB
Bit 6 Bit 5
Ref From Ref From
Net Net
Bit 6 Bit 5
Bit 4 Bit 3
Ready Running
Reverse
Bit 4 Bit 3
Configurar bus de campo
7.6 Comunicación vía EtherNet/IP
Bit 2 Bit 1
Running Warning
Forward
Bit 2 Bit 1
Fault
Reset
Bit 0
Faulted
Bit 0
RUN
Forward
155