Alarm Functions - Malaguti SPIDER MAX GT 500 Manual Diagnóstico

SPIDER MAX 500
2.3 Air temperature function
The information is displayed on the lower part of the display along with the
icon TEMP. The 2-coded digit (plus sign) information is stored in a volatile
memory and is always expressed in Celsius degrees.
When the sensor is not properly connected to the equipment two horizontal
dashes are displayed instead (F. 5).
• Strategy: the actual temperature detected by the sensor is displayed.
• The displayed function cannot be changed in any way.
• The information is updated every 0.5 sec.
• Displayed limits: -10 °C.....+ 55 °C.
• Measure tolerance: ±1°C.
2.4 Clock function (TIME)
The information concerning the current time is displayed on the upper part of the display, in hh:mm format (see F. 1). To
adjust the current time, switch the motorcycle off and access the set-up menu.
• Displayed sequence: from 0:00 to 23:59.
• The information concerning the current time IS NOT stored in the memory.
• Clock precision: ± 2.5"/day.
• The Time function is always visible, except with the Preventive Maintenance function on.
3. ALARM FUNCTION
3.1 ICE Alarm
In case the sensor reads a temperature below 4 °C, the system starts the
alarm routine to warn that there could be ice on the street: with any function
displayed, the system shows the message *** ICE (F. 6), which blinks for 15
seconds (f=1 Hz, duty=50%). After the indicated period of time, the display
goes back to the function previously displayed while the * ICE icon moves
to the lower left hand side of the display (and all the information usually
displayed on this area will be moved to make room for the new blinking
information (f=1 Hz, duty=50%) (see F.7). This configuration aims at warning
the user that there may be ice on the street, but does not affect the equipment
operation in any way: in fact all its functions are available beside the warning
message. The alarm situation ends when the sensor reads a temperature
above 5 °C. The whole sequence will be repeated every time that the read
temperature is below or equal to 4°C and is interrupted whenever the read
temperature is above or equal to 6°C.
• While the warning message is on (15 sec.), the MODE button is disabled.
• While the warning message is on (15 sec.), the only functions that persist
on the display are "Fuel" (fuel level indicator), "wtemp" (radiator coolant
temperature) and hydraulic stand alarm (when present).
• The alarm is displayed with any function selected.
• When the selected function is "Service", the alarm routine stops after
15 sec.
All manuals and user guides at all-guides.com
11
F. 5 Outside temperature
F. 6 ICE alarm (after 15")
F. 7 ICE alarm (after 15")
03/05
A