Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 165

SPIDER MAX 500
6.3 Connection circuit check of the "Diagnostic multimeter"
• In case the message "central unit is not responding" is displayed on the diagnostic
multimeter, cut the dashboard supply for 10 seconds and then switch it ON again. If the
warning message persists follow the instructions indicated below:
Check the diagnostic multimeter connectors and wiring:
A) Diagnostic plug
B) 12 Volt supply plug
A
A
F. 8
Check the central unit and dashboard
supply.
(See paragraph 9.1 - page 50 -
paragraph 9.2 - page 52).
Connect the testing wiring (code
08607600) to the motorcycle system
connector leaving the EMS central
unit disconnected.
F. 9
All manuals and user guides at all-guides.com
39
Restore connectors and/or wiring.
03/05
B
CENTRAL UNIT IS NOT
RESPONDING
CHECK CONNECTIONS
PARAMETERS 1/4
B