SPIDER MAX 500
- Select the diagnostic multimeter
function from "TPS reset".
- Make sure that the gas valve
control rests on the locking screw
(A).
- Making sure to retain this position,
confirm to start the TPS reset
procedure.
- Select the "PARAMETERS"
function and make sure the TPS
reset "YES" is present.
Carry out the reset procedure in the following situations:
- when assembling the equipment for the first time
- when replacing the throttle body
- when replacing the injection central unit.
NOTE - Do not carry out the TPS reset procedure with a used throttle body as the valve wear and even
the smallest opening may change the air flow with respect to the calibration air flow.
All manuals and user guides at all-guides.com
108 12/04
Immobilizer
Errors
Delete errors
Active diagnostics
CO calibration
Reset TPS
Main
Check the
throttle stroke
Press OK to
start the TPS
reset
Lost synchronisations 1D
Lost synchronisations > 1D
TPS reset
CO already calibrated
R/O step difference
Atmospheric press . mm Hg
Parameters
B
7/8
0
0
YES
NO
55
783.0
3/3