Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 163

All manuals and user guides at all-guides.com
B
SPIDER MAX 500
6.1 How to use the diagnostic multimeter (code 08607500)
The EMS system diagnostic equipment (F. 4) is connected to the central unit by means of a EMS diagnostic plug
located under the driver seat (F. 2/a - page 34 - component no. 7).
Remove the protection cap and connect the diagnostic multimeter terminal.
F. 7
Supply the diagnostic multimeter by connecting the terminals to the battery poles, or the specific connector to the plug
located inside the helmet compartment (F. 7). Both supply cables are supplied with the motorcycle. (The system is
protected against polarity inversion).
The equipment starts up whenever it is connected to the power supply (no ON/OFF button present).
The system is equipped with a display, showing all the available functions, and the following push-buttons:
ESC
OK
UP
DOWN
TAB
Press the ESC button to leave the function or exit the displayed menu (except the main menu).
Press the OK button to confirm the selection made.
Press the UP and DOWN buttons to scroll the menu UP and DOWN.
Press the TAB button to display the menu functions.
Every time one of the buttons is pressed a Beep is heard: it indicates that the equipment received the command.
The DISPLAY shows 6 lines a time: a number displayed underneath any of the 6 lines indicates the number of the
function out of the total (e.g.: 1/ 7 indicates that the function displayed if the first out of the seven contained in the menu).
When starting up the equipment the MALAGUTI logo will be displayed.
Press any button to display the page containing all the information about the type of central unit the equipment was
designed for.
Press any other button or wait for 5 seconds to access the main menu.
At this point, scroll the menu by using the UP and DOWN buttons in order to select the required sub-menu and press the
OK button to access the sub-menu.
After accessing the sub-menu, select the required function and confirm by pressing the OK button again.
37 12/04