Oil Alarm De-Activation (Oil) - Malaguti SPIDER MAX GT 500 Manual Diagnóstico

All manuals and user guides at all-guides.com
A
SPIDER MAX 500
4.3.1 Display mode quick selection
The selection procedure of the (Normal or Reverse) display mode described in the previous paragraph could result quite
difficult, for this reason, considering that the user may need to change the display mode quite often, a quick selection
routine has been implemented allowing the user to carry out this operation while driving. This routine can be selected
only when the STAND-BY function is selected. In the described situation, if the button is not pressed within 5 seconds,
the system will display the TOD function. If the button is pressed for less than 2 seconds, the system changes the main
menu function; if the button is pressed for more than 2 seconds, the system goes to the Set-up menu display function
(F. 14), where the only options that can be selected are Normal and Reverse. It is possible to exit the menu in two ways:
1) without pressing the button within 20 seconds;
2) by selecting a display mode.
This procedure allows the user changing the display mode (from Normal to Reverse and vice versa) by simply holding
the button down (after selecting the STAND-BY function) and without looking at the display. This routine, in fact, can be
performed while driving and thus be quite dangerous for the user that could move his/her attention from the road to the
display.
4.4

OIL ALARM de-activation (OIL)

The de-activation of the OIL CHECK or CHANGE ALARM must be performed only by authorised personnel according to
the following procedure:
• Position the key switch on the "OFF" position.
• With the key on the "OFF" position, press the mode button.
• Holding the mode button down, move the key to the "ON" position.
At this point, the system will display the Set-up menu (F. 11), from which it is possible to select the OIL function (only
OIL, V.BELT and EXIT can be selected). It is then possible to de-activate the OIL Alarm by pressing the button for at
least 2 seconds. This procedure allows the authorised Dealer to inform the system that the service operations have been
carried out and generates a confirmation message (OIL ALARM OFF) that will lasts for at least 15".
Note 1: While the confirmation message is on, the button function is disabled.
Note 2: The OIL ALARM can be de-activated at any time without waiting for the decreasing counter, associated
with this function, to get to the zero.
Note 3: After de-activating the alarm, the system automatically sets the equipment to the standard operation
mode. To access the de-activation configuration again, repeat all the operations above described.
4.5 V.BELT ALARM de-activation (V.BELT)
The V.BELT CHANGE ALARM de-activation must be performed only by authorised personnel according to the following
procedure:
• Position the key switch on the "OFF" position.
• With the key on the "OFF" position, press the mode button.
• Holding the mode button down, move the key to the "ON" position.
At this point, the system will display the Set-up menu (F. 11), from which it is possible to select the V.BELT function (only
OIL, V.BELT and EXIT can be selected), it is then possible to de-activate the V.BELT Alarm by pressing the for at least
2 seconds. This procedure allows the authorised Dealer to inform the system that the service operations have been
carried out and generates a confirmation message (V.BELT ALARM OFF) that will lasts for at least 15".
16 12/04