Publicidad
Idiomas disponibles
Idiomas disponibles
Stimulation Amplitude
Whenever stimulation is turned on, or after the Remote Control is awakened from sleep
mode, the Remote Control display defaults to the Level screen.
Note: When there is no button activity for more than 60 seconds, the Remote Control
will transition to sleep mode and the display screen will be blank.
Usually, changes to the amplitude of stimulation will not be permitted using the Remote
Control. In these cases, the physician should determine the optimal amplitude for
stimulation therapy. However, for certain patients, physicians may allow patients to
change stimulation levels.
If the physician has allowed control of the stimulation amplitude, press the ▲ or ▼
button from the Level screen to increase or decrease the amplitude. The triangular ramp
in the center of the screen will fill as the stimulation amplitude increases.
Stimulator Battery
The Level screen also displays a battery graphic near the top center of the screen to
indicate the battery level of the Stimulator. The graphic is easy to understand: three filled‑
in bars means that the Stimulator has a fully-charged battery.
Note: The battery graphic indicates the battery level of the Stimulator, not the Remote
Control.
As the battery strength wears down, depending on the stimulation parameters and
usage, the bars will empty, as shown in the chart below. For complete information on
maintaining the Stimulator's battery, see "Charging the Stimulator" on page 40.
Battery Graphic
The Stimulator's battery is full.
The Stimulator's battery is ok.
The Stimulator's battery is low.
Description
Vercise™ DBS Physician Manual
91098825-11
The Remote Control
49 of 341
Publicidad
