Map-Controlled Cdi Unit - Yamaha WR426F Manual De Servcio Del Propietario

MAP-CONTROLLED CDI UNIT

A map-controlled, CDI ignition system is used in the WR426F/WR400F.
The microcomputer in the CDI unit detects the engine speed and throttle position, thus determining
the optimum ignition timing through the entire operating range. In this way, quick throttle response
can be achieved according to various riding conditions.
Throttle position sensor
Function of Component
Component
TPS
(throttle position sensor)
Pickup coil
CDI unit
Principal of 3-Dimensional Control
Conventionally, ignition timing was controlled only
by engine revolutions (2-dimensional control).
However, ignition timing needs advancement also
by engine load. Thus, accurate ignition timing can
be determined by adding throttle opening to deter-
mine ignition timing (3-dimensional control).
MAP-CONTROLLED CDI UNIT
CDI unit
Detects throttle valve opening and inputs it into the computer in the
CDI unit as a throttle opening signal.
Detects signal rotor revolutions and inputs them into the computer in
the CDI unit as engine revolution signals.
The signals of the TPS and pickup coil sensor are analyzed by the
computer in the CDI unit, which then adjusts ignition timing for the
operation requirements.
6 - 2
ELEC
Ignition coil
Pickup coil CDI magneto rotor
Function
3-D Image Map of Ignition Timing
(different from actual characteristics)
– +