Tabla de contenido
Publicidad
Å
ı
FRONT BRAKE AND REAR BRAKE
5 - 27
2. Air bleed:
Brake system
Refer
to
"BRAKE
BLEEDING" section in the CHAPTER
3.
3. Inspect:
Brake fluid level
Fluid at lower level → Fill up.
Refer
to
"BRAKE
INSPECTION" section in the CHAP-
TER 3.
4. Install:
[Front]
Diaphragm
Master cylinder cap 1
Screw (master cylinder cap) 2
2 Nm (0.2 m · kg, 1.4 ft · lb)
[Rear]
Diaphragm
Reservoir tank cap 1
Screw (reservoir tank cap) 2
2 Nm (0.2 m · kg, 1.4 ft · lb)
Master cylinder guard
10 Nm (1.0 m · kg, 7.2 ft · lb)
CAUTION:
After installation, while pulling the lever in
or pushing down on the pedal, check
whether there is any brake fluid leaking
where the union bolts are installed respec-
tively at the master cylinder and caliper.
Å Front
ı Rear
5. Install: (rear brake only)
Protector 1
Bolt (protector) 2
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS
SYSTEM
AIR
FLUID
LEVEL
Publicidad
Tabla de contenido
