Yamaha WR426F Manual De Servcio Del Propietario página 632

HANDLEBAR
5. Install:
Throttle cable cap 1
Screw (throttle cable cap) 2
Cover (throttle cable cap) 3
WARNING
After tightening the screws, check that the
throttle grip 4 moves smoothly. If it does
not, retighten the bolts for adjustment.
6. Install:
Master cylinder 1
Master cylinder bracket 2
Bolt (master cylinder bracket) 3
NOTE:
Install the bracket so that the arrow mark a
faces upward.
First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
7. Install:
Lights switch 1
8. Install:
"ENGINE STOP" button 1
Clutch lever holder 2
Bolt (clutch lever holder) 3
Decompressor lever holder 4
Bolt (decompressor lever holder) 5
Clamp 6
5 - 44
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
9 Nm (0.9 m · kg, 6.5 ft · lb)
2 Nm (0.2 m · kg, 1.4 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)