Tabla de contenido
Publicidad
REAR SHOCK ABSORBER
2. Install:
NOTE:
Apply the molybdenum disulfide grease on
the bearing.
Apply the lithium soap base grease on the
bush, collars and dust seals.
Install the dust seals with their lips facing
outward.
3. Install:
4. Install:
NOTE:
Apply the molybdenum disulfide grease on the
bolt.
5. Install:
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Insert the bolt from right side.
6. Install:
7. Tighten:
1
5 - 65
CHAS
Bush 1
Collar 2
Dust seal 3
Rear shock absorber
Bolt (rear shock absorber-frame) 1
Nut (rear shock absorber-frame) 2
56 Nm (5.6 m · kg, 40 ft · lb)
Plain washer 1
Bolt (rear shock absorber-relay arm) 2
53 Nm (5.3 m · kg, 38 ft · lb)
Rear frame 1
Bolt (rear frame) 2
29 Nm (2.9 m · kg, 21 ft · lb)
Bolt (reservoir tank) 3
10 Nm (1.0 m · kg, 7.2 ft · lb)
Screw (air cleaner joint) 1
3 Nm (0.3 m · kg, 2.2 ft · lb)
Publicidad
Tabla de contenido
