Inspection Of Fuel Pump And Needle Valve; Disassembly And Inspection Of Fuel Pump - TOHATSU EverRun MX50D2 Manual De Servicio

Fuel System
1
1
3 1
1 1
4-24
All manuals and user guides at all-guides.com
4) Inspection of Fuel Pump and
Needle Valve
Connect vinyl hose 1 to inlet of fuel pump.
1.
Place carburetor body upside down to shut off needle valve.
2. Apply pressure, and check if the pressure is maintained for
10 seconds. Disassemble and inspection if necessary.
5) Disassembly and Inspection of Fuel
Pump
1. Remove float chamber of #3 carburetor to disassemble Fuel
Pump.
Check diaphragm 1 for break, crack and damage, and
2.
replace if necessary.
2 2
Check check valve 2 for damage and deterioration, and
3.
replace if necessary.
1 1
Check fuel pump body 3 for crack and damage, and
4.
replace if necessary.
5. Clean fuel pump body.
Vacuum Pressure Gauge
P/N. 3AC-99020-1
It can instantly check to apply pressure by your
breath, when without pressure gauge.
CAUTION
To prevent fuel from dripping on the floor,
use a vessel to catch the fuel.
GB
2st 50D2 2011