Assembling Rubber Mounting - TOHATSU EverRun MX50D2 Manual De Servicio

Bracket
1342
1342
1
5
4
0
8
7-38
All manuals and user guides at all-guides.com
7.
3 3
0 0

9) Assembling Rubber Mounting

3
When assembling drive shaft housing parts, reverse the
disassembling procedure.
1.
2
a
2.
3.
b
4.
7
9
6
5.
c
6.
Install engine base 3 to drive shaft housing 0 by
tightening installation bolts to specified torque.
Engine Base Bolts :
20 N · m (14.5 lb · ft) [2.0 kgf · m]
Install upper mount 1 and tighten bolts 2 to specified
torque.
CAUTION
Install the mount with the side of longer
a facing forward.
size
Upper Rubber Mount Bolts 2 :
29 N · m (22 lb · ft) [2.9 kgf · m]
Install upper mount holding plate 3.
Install dumper rubber 5 to mount bracket 4.
CAUTION
Install dumper rubber with the grooved
side c facing drive shaft housing.
Put lower rubber mount 6 to drive shaft housing and
tighten bolts 7 and nuts 8 to specified torque.
CAUTION
Install the mount with the side of longer
size b facing forward.
Lower Rubber Mount Bolt and Nut 7 and 8 :
41 N · m (27 lb · ft) [4.2 kgf · m]
Install mount holding plates 9.
Attach ground wire 0.
GB
2st X50D2 2011