Publicidad
Lower Unit
1
3
4
WX50 only
6-52
All manuals and user guides at all-guides.com
19) Removing Drive Shaft Ass'y
1.
Remove pinion (B) gear nut
(B) gear 3 and drive shaft.
2
3
4
2.
Pull out drive shaft from gear case.
Remove drive shaft spring guide 5.
3.
5
4, and then, remove pinion
· Degrease pinion (B) gear nut completely so that
the nut wrench does not slip on the nut.
· Loosen and remove the nut by using a drive
shaft socket and a wrench and turning the
wrench counterclockwise. Cover the wrench 2
with rag to prevent it from hitting the case
directly.
· This work can be made easier when the opening
of gear case of propeller shaft side is faced
upward and fixed horizontally with a holder.
Drive Shaft Socket 1 :
P/N. 345-72232-0
Bevel Gear B Nut Wrench 2 :
MX:P/N. 346-72231-0
MWX:P/N. 353-72231-0
· When removing drive shaft, be careful not to
give damage to shim on the bearing outer race
and not to lose the part.
· Replace shim with new one of the same
thickness if any deformation or damage is found
on it.
GB
2st 50D2 2011
Publicidad
Capítulos
Solución de problemas
