Publicidad
Bracket
2
2
2
7-46
All manuals and user guides at all-guides.com
13) Disassembling Clamp Bracket
1
1
1
1.
Remove drive shaft housing, steering shaft, thrust rod and
copilot before beginning this procedure.
Loosen nut 2 of swivel bracket shaft 1.
2.
3.
Remove ground cable on the swivel bracket.
4.
Remove swivel bracket shaft with spring and swivel
bracket.
WARNING
· When disassembling clamp bracket, be
sure to fully tilt up outboard motor. If
outboard motor is fully tilt down it can
pop out spring suddenly and result in
severe injury.
· When tilting up outboard motor without
power unit installed, be careful to
operate tilt lock lever to prevent swivel
bracket rise up easy.
GB
2st X50D2 2011
Publicidad
Capítulos
Solución de problemas
