Publicidad
Power Unit
3
5-48
All manuals and user guides at all-guides.com
10) Inspection of Cylinder Head
1.
Remove carbon deposit in the combustion chamber of
cylinder head, and check the interior for degradation,
damage and other defects.
2.
Check water jacket interior for deposits.
Use straight edge 2 and thickness gauge 3 to check
3.
2
distortion of cylinder head 1 in the directions shown.
Repair or replace if the distortion is over the specified limit.
1
4.
If the distortion is over the limit, lap the component by
using a sheet of sand paper #240 - #400 placed on a
surface plate or thick place glass and moving it on the
paper drawing the letter "8" on it. Finish by using sand
paper #600 - #1000.
When cleaning mating surfaces of cylinder head
by using a means such as a scraper or wire
brush, be careful not to scratch the surfaces.
Thickness Gauge :
Commercially Available Item
Functional Limit :
0.03 mm (0.00118 in)
GB
2st X50D2 2011
Publicidad
Capítulos
Solución de problemas
