Lower Unit
4
3
5
5 Spring Pin
Do not reuse.
8 Split Pin
Do not reuse.
6-104
All manuals and user guides at all-guides.com
Connect shift rod joint 3 and shift rod 4, and drive in
5.
spring pin 5.
6
6.
Attach propeller and tighten propeller nut 7 to specified
torque.
8
7
Attach split pin 8.
7.
8.
Fill gear case with gear oil to specified level.
Refer to "Replacement of Gear Oil" in Chapter 3.
· Do not reuse spring pin.
· Replace with new one when removed.
Spring Pin Tool B 6 : (ø3.0)
P/N. 345-72228-0
CAUTION
· Before removing or installing propeller, be
sure to remove stop switch lock plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between
anti-ventilation plate and propeller to
prevent rotation of propeller when
removing or installing propeller.
Propeller Nut 7 :
35 N · m (25 lb · ft) [3.5 kgf · m]
CAUTION
If propeller shaft pin hole and propeller nut
pin groove do not align, additionally tighten
the nut until they align.
Perform "Inspection of Gear Case (Air Leakage)"
in Chapter 3 if necessary.
GB
2st 50D2 2011