Electrical System
1
8-12
All manuals and user guides at all-guides.com
5. Inspection Items
1) Inspection of Ignition and spark
1.
Disconnect plug cap 1 from spark plugs.
Connect plug cap 1 to spark tester.
2.
3.
Connect spark tester clip to spark plug tip electrode.
4.
Start engine and check spark. Check spark system when
sparks are weak.
2) Inspection of Plug Cap Terminal
1.
Disconnect plug cap from spark plug.
2.
Check spark plug hole of spark plug cap and check
position of spark plug terminal to properly.
3.
Replace plug cap terminal if necessary.
WARNING
· Do not touch any connection of wires of
"Spark Tester", while checking ignition
spark.
· When testing, put electrode cap assuredly
to prevent direct contact with spark
tester wiring and leak of electrical
current, and perform test carefully.
· Keep flammable gas, fuel, oil away from
tester to prevent them from catching
sparks. If not using an in-line tester,
remove fuel injector connectors when
checking spark.
This test can be made without removing parts.
Spark Tester :
P/N. 3F3-72540-0
Spark Performance :
10 mm (0.4 in) or over
Remove the part and test it as a separate unit.
GB
2st 50D2 2011