Assembling Crank Ass'y And Crank Case - TOHATSU EverRun MX50D2 Manual De Servicio

Power Unit
a a
c c
518
518 518
a a
5-76
All manuals and user guides at all-guides.com
3. Positioning bearing
Put the pin a of bearing (lower) on the cylinder.
b b
4. Positioning Bearing
22) Assembling Crank Ass'y and Crank
Case
1. Degrease crank case and cylinder mating faces.
2. Apply sealing agent to crank case's mating surface.
518 518
3. When installing crank case, check position of dowel pins
a.
a a
Face the pin of ball bearing of all, to upward. Rise
crankshaft lightly, and then turn bearing to fit the
pin in the cylinder grooves b.
· Attempt to move each bearing lightly to check if
dowel pin is in the hole snugly.
· Main bearing is provided with a oil journal c on
the opposite side of knock hole to check the
location.
Crank Case Mating Surface :
Loctite #518
518 518
· Be careful not to allow sealing agent to squeeze
out.
· Apply sealing agent on the area inside of the bolt
holes continuously in width of approximately 1
mm as shown.
518
GB
2st X50D2 2011