Stiga RC 585 Manual De Instrucciones página 134

2. Check lubricant in reduction box
• Put the tiller on a horizontal ground and screw out the plug (See Fig.4).
• Advise append appropriate lubricant to the reduction box every 50 hours.
• Recommended lubricant is Calcium base grease .
3. Check air filter
Warning!
Never try to run the engine without the air filter, if so, the engine will be worn
more quickly.
4.2. STATUS ADJUSTMENT OF THE TILLER
1. Adjustment of handle frame
Note: Before adjusting height of handle frame, please put the machine on a flat horizontal
ground to prevent it from accidental falling.
• Loosen the lifting handle and select the hole in an appropriate position, then adjust the handle's
cross bar to as high as user's waist, then turn the lifting handle to tighten it (See Fig. 5).
2. Adjustment of tilling depth:
• By adjusting height of damping lever, tilling depth can be adjusted. Specifically, adjusting the lever
downward will increase tilling depth, and adjusting it upward will decrease tilling depth. (See Fig. 6).
6
Figure 4
Figure 5 Figure 6
EN