Publicidad
Idiomas disponibles
Idiomas disponibles
Steps to adjust the engine:
a) Observe whether connection points of the accelerator cable are loose or have broken off, if so, retighten
them to their original places.
b) Turn accelerator valve regulator on the handle frame to the maximum adjustable position without load,
and then adjust the speed adjusting bolt of the gasoline engine's accelerator operation mechanism to
a proper position.
c) After long work, the user may adjust the fine-adjusting bolt of the accelerator cable to adjust the engine.
6. Use the clutch of reverse gear:
Warning!
Before using the clutch of reverse gear, lower the engine speed.
• By "engage " and "disengage "of the clutch of reverse gear, the user can control output of engine's
power.
• When the user holds tight the clutch lever, the clutch is engaged and transmits engine power to the
tiller and tilling blades begin to reverse rotate (See Fig. 14).
• When the user releases clutch lever, clutch will be disengaged, and the engine power can't be
transmitted to the tiller, and tilling blades stop rotating (See Fig. 15).
Note: When using the clutch of reverse gear , especial pay attention to safety . Sure , improper
adjustment of clutch cable will affect normal use of the product.
7. Adjustment of front wheel:
• Adjust front wheel of tiller to the state shown in Fig. 15 when it is going to drive on the road.
• Adjust front wheel of tiller to the state shown in Fig. 16 when it is going to till the field.
EN
Figure 14
Figure 15
Figure 15
Figure 16
9
Publicidad
