8.
TROUBLE SHOOTING
If the engine can't be started, please check
1. Whether the engine switch is in the ON position,
2. Whether there is enough lubricant in the machine,
3. Whether fuel valve is in the ON position,
4. Whether there is fuel in the fuel tank,
5. Whether fuel can be delivered into carburetor, to check this, the user can loosen drain bolt of
carburetor and set the fuel valve to the ON position.
Warning!
If any fuel is spilled out, thoroughly remove it and let it dry up before checking
spark plug or starting the engine, because fuel spilled out and its vapor may
cause a fire.
6. Whether the spark plug can spark.
a) Pull off the spark plug cap, remove dirt from it, then detach the spark plug.
b) Fit spark plug cap over the spark plug.
c) Contact the metallic case of spark plug to engine's cylinder head. Slightly pull the starter to check
if sparks are produced. If so, refit the spark plug and start the engine.
7. If the engine still cannot start, please repair it at an authorized distributor's shop.
18
Drain bolt
EN