ECL-76, ECL-102
This device may only be repaired by qualified personnel. Inadequate repairs
can cause considerable hazards.
If your device should need repairing, please contact your specialist dealer.
People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this product
safely should not use it without the supervision or instruction of a responsible
person.
When installing the charging current distributor, ensure that it will be out of the
reach of children.
2.2
Operating the device safely
WARNING!
!
Do not operate the device near flames or other heat sources (heating, direct
sunlight, gas ovens, etc.).
Never immerse the device in water.
Protect the device and the cable against heat and moisture.
To prevent short circuits, always disconnect the negative terminal of the ve-
hicle battery before working on the vehicle electrical system.
If the vehicle has an additional battery, its negative terminal should also be
disconnected.
Inadequate cable connections can cause short circuits, resulting in:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
3
Target group
The installation information in this manual is intended for qualified personnel at work-
shops who are familiar with the guidelines and safety precautions to be applied during the
installation of electronic vehicle accessory parts.
4
Scope of delivery
Quantity
Description
1
Control unit
1
High-current load relay
EN
Target group
51