Comando Add; Comando Modify - Avaya Octel 200 Manual Del Administrador

Comando Add

Utilice el comando ADD BUS para añadir números de identificador de BUS a la tabla BUS
INFORMATION.
.A BUS
ADD:2
ADD:
ADD:
ADD:
ADD:
ADD:
ADD:2
--- BUS ID 2

Comando Modify

A continuación se reproducen las preguntas formuladas cuando se modifica la tabla BUS
INFORMATION. A fin de modificar una línea de enlace, utilice el comando MODIFY BUS TRUNK.
Las preguntas formuladas cuando se modifica una línea de enlace aparecen después de las
correspondientes al BUS.
.M BUS
MOD:2
MOD:
MOD:
MOD:S
PB60018-11 Rev B
Enter the BUS ID NUMBER for the TRUNK INTERFACE MODULE to
add to this INSTALLATION (1-31).
Enter empty line when done.
Enter DEVICE TYPE FOR THIS MODULE. (1=DID, 2=E&M, empty line=DID)
Does this DID INTERFACE MODULE have a direct RS232 connection?
(Y/N, empty line=Y)
Is this DID INTERFACE MODULE ON-LINE?
(Y/N, empty line=Y)
What is the CENTRAL OFFICE (CO) type?
(C=common control or
How many trunks are in this DID INTERFACE MODULE?
(1-24, empty line=24)
What is the SIGNALING TYPE for the DID trunks?
(1=immediate, 2=wink, 3=delay dial, empty line=immediate)
COMPLETE ---
Enter the BUS ID NUMBER for the TRUNK INTERFACE MODULE
to modify (1-31).
Enter empty line when done.
Does this DID INTERFACE MODULE have a direct RS232 connection?
(Y/N, empty line=Y)
Is this DID INTERFACE MODULE ON-LINE?
(Y/N, empty line=Y)
What is the CENTRAL OFFICE (CO) type?
(C=common control or
S=step-by-step, empty line=common control)
S=step-by-step, empty line=common control)
Tabla BUS INFORMATION
.A BUS
.M BUS
Octel 200/300
3-5
S 4.1