Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 107

Display Status Text For Cinematographer or Director
Your URSA Mini's LCD touchscreen displays information such as ISO, white balance, and
aperture that is useful to a camera operator or cinematographer setting up individual shots on
that camera. URSA Mini's front and main SDI outputs, however, can also show information useful
to a director or script supervisor who is keeping track of multiple shots or cameras.
Your URSA Mini can display director specific status text on its front and main SDI outputs
Setting the status text to 'director' in your URSA Mini's 'front SDI' or 'main SDI' monitor settings
changes the status text for that output to show the following information.
FPS
Displays the currently selected frames per second for that camera. If off speed frame
rate is disabled, only the project frame rate will be shown. If an off speed frame rate is
being used, the sensor frame rate will be shown, followed by the project frame rate.
CAM
Displays the camera index as set in your URSA Mini's Slate. See the 'slate' section later
in this manual for more information.
OPERATOR
Identifies the camera operator as set in your URSA Mini's Slate. See the 'slate' section
later in this manual for more information.
DURATION DISPLAY
Displays the duration of the current clip, while recording, or the last recorded clip in the
following format: hours:minutes:seconds
REEL, SCENE, TAKE
Displays the current reel, scene and take. For more information on reels, scenes, takes
and their labelling conventions, refer to the 'slate' section later in this manual.
DYNAMIC RANGE
The bottom left hand corner of the monitor displays your URSA Mini's currently
applied LUT, if applied to that output. If no LUT is applied, 'film' or 'video' dynamic
range will be displayed.
TIMECODE
The bottom right of the monitor displays your URSA Mini's timecode, in the following
format: hours:minutes:seconds:frames
Settings 107