Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 197

The Blackmagic Studio Fiber Rack Kit contains the following items:
Preparing the Blackmagic Studio Fiber Converter for installation into a rack:
1 Position the blanking panel on one of the sides of your Studio Fiber Converter,
depending on whether you would like the unit to sit on the left or right side of the
rack shelf. The front face of the blanking panel should be parallel with the front panel
of the unit.
2 Attach the blanking panel to the side of your Studio Fiber Converter near the front
using three of the supplied blanking panel screws.
3 Use three of the supplied rack ear screws to attach a rack ear to the other side of your
Studio Fiber Converter.
With the rack ear and blanking panel attached, you can now install your converter into
a standard two rack unit space using the mounting holes on both sides and standard
rack screws.
2x Rack ears
Attach rack 'ears' to the outside edge of
Blackmagic Studio Fiber Converter for mounting
in a rack
1x Half rack width blanking panel
The blanking panel has a mounting ear on one
side so you can cover the empty rack space if
you are installing a single unit. The illustration
shows the ear on the right side. Simply rotate
the panel 180° to mount it to the other side.
2x Support brackets
The T-shaped support brackets attach
underneath the two Studio Fiber units where
the two units meet at the front and the rear
to provide support.
Screws
8 x M4 10mm 4 x M4 8mm
Rack Blanking
ear screws panel screws
Operating the Studio Fiber Converter
5 x M3 5mm
Support
bracket
screws
197