Ptz Interface; Audio Outputs - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

PTZ Interface

Both the studio unit and camera unit has a 9 pin DE-9 connector so you can connect a PTZ
controller at the studio end, and the remote head at the camera end. The PTZ commands are
embedded in the SDI signal connected between the units via the SMPTE fiber cable.
The settings menu on Blackmagic Studio Fiber Converter lets you select the source of PTZ
commands that are sent to your Blackmagic Camera Fiber Converter. You have the option to
select from the PTZ connector on the back of the Studio Fiber Converter or a program SDI feed
coming from an ATEM Switcher instead. For more information, refer to the 'operating the studio
fiber converter' section.
PTZ Interface Pinout Diagram
External view
5 3 1
4 2
9 7
8 6
9 pin 'PTZ' connector

Audio Outputs

The four XLR audio outputs on the studio unit give you the option to output the audio plugged
into inputs 1 and 2 from your URSA Mini or URSA Broadcast camera, and the two XLR audio
inputs on the Camera Fiber Converter.
Outputs 1 and 2 on the studio unit correspond to embedded XLR input channels 1 and 2 on
URSA Broadcast or URSA Mini by default. Outputs 3 and 4 on the studio unit correspond to XLR
inputs 1 and 2 on the Blackmagic Camera Fiber Converter by default. You can use the menu to
change these settings for mapping. For more information, see the 'using the menu' section.
Pins Signal
1 GND
2 RS422 Tx-
3 RS422 Rx+
4 GND
5 N/C
6 GND
7 RS422 Tx+
8 RS422 Rx-
9 GND
Studio Unit Connections 207