Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 286

3
Attach URSA Mini Recorder's mounting bracket
using 6 x T10 torx screws.
5
Attach URSA Mini Recorder to the mounting
bracket using 2 x T10 torx screws on the left and
right side of the brackets.
7
If you want to use a battery plate with URSA Mini
Recorder, use a 2mm hex key driver to remove
the four M3 screws holding the molex socket
cover panel in place. Once the molex socket is
uncovered, attach a battery plate using the steps
outlined in the section 'mounting batteries' in this
manual.
4
Plug the molex connector on
URSA Mini Recorder into the molex
socket on your camera's rear panel.
6
Connect the Mini Recorder's USB-C cable
to the USB-C data port on the rear of
URSA Mini Pro 12K. Tighten the locking
connectors with your fingers, or use a
2mm hex key driver. To use with URSA Mini Pro
4.6K G2, use a longer USB-C cable and connect
it to the USB-C port above the CFast slots.
URSA Mini Recorder 286