Audio Settings; Audio Settings - Ursa Mini - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

Audio Settings

The 'audio' tab lets you adjust the audio input and monitoring settings on your URSA Mini.
This menu is slightly different between URSA Mini and URSA Mini Pro models, so the available
settings are described separately below.
Audio Settings – URSA Mini
The audio settings for your URSA Mini are divided by audio input source between 'camera' and
'XLR' for onboard and externally sourced audio. 'XLR' settings are spread over two pages,
which you can cycle through by tapping the arrows at the edge of the LCD touchscreen or
swiping left or right.
Camera Audio Settings
When you select 'camera' audio input, your URSA Mini will have one page of audio settings
available. The 'camera' audio tab contains the following settings.
Headphones Volume
This slider adjusts the output levels for headphones attached to URSA Mini's 3.5mm headphone
jack. Move the audio slider left or right to adjust levels.
Speaker Volume
This slider adjusts the output levels for your URSA Mini's built in speaker. Move the audio slider
left or right to adjust levels.
Camera Internal Mic
This slider adjusts the recording levels for your URSA Mini's built in microphone. Move the audio
slider left or right to adjust levels. The built in microphone records to audio channels 1 and 2.
Low Cut Filter
Tap this switch icon to enable the low cut filter for your camera's internal microphones. This filter
helps to reduce potential wind noise or low frequency rumbling that may occur in exterior
shooting conditions. Note that the 'pad audio by -15 dB' selector must be switched off for this
function to work.
Pad Audio By -15dB
The -15dB pad option gives you added control to further reduce the microphone input gain
levels on your URSA Mini's internal microphone when shooting in a loud environment even after
your input levels are already turned down.
Settings 112