Plugging In Camera Sdi; Plugging In Return Sdi Outputs; Mounting Blackmagic Camera Fiber Converter - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

Plugging in Camera SDI

Connecting video signals between your Blackmagic Camera Fiber Converter and URSA Mini
or URSA Broadcast, is as simple as connecting two of the three included SDI cables from the
side of your converter to the rear of your camera.
How to connect your Camera Fiber Converter to your camera
1
Connect one of the included BNC cables from Blackmagic URSA Mini or
URSA Broadcast's rear 12G-SDI output to the SDI input on Blackmagic Camera
Fiber Converter.
2 Connect one of the included BNC cables from the SDI output on Blackmagic Camera
Fiber Converter to the 12G-SDI input on Blackmagic URSA Mini or URSA Broadcast's
rear panel.

Plugging in Return SDI Outputs

The three SDI outputs marked 'SDI Out' on the front of the camera unit are loop outputs of the
return feeds coming from the switcher. These let you connect the return feeds to other SDI
equipment near the camera, for example a teleprompter or talent monitor.
The three return feed loop outputs can be
connected to SDI equipment near the camera,
for example a teleprompter or monitor
NOTE The return feed SDI loop outputs support 3G-SDI to provide enough bandwidth
for three separate feeds. This means Ultra HD return feeds from the switcher up to
2160p60 are down converted to 1080p at the equivalent frame rate.
Mounting Blackmagic Camera Fiber Converter
Blackmagic Camera Fiber Converter mounts to the back of URSA Mini and URSA Broadcast
directly behind the camera body, and connects to your camera's rear SDI in and SDI out
BNC connectors. If you have installed a battery plate to the rear of your camera, you will need
to remove it before connecting the Blackmagic Camera Fiber Converter.
Getting Started with Blackmagic Fiber Converters 182