Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 184

5
Slide the Blackmagic Camera Fiber Converter
onto the mounting bracket, and attach it using
2 x 2.5mm Hex screws on each side of the
bracket.
NOTE When setting up your production and using URSA Mini or URSA Broadcast with
the fiber unit attached, it's important to maintain some clearance underneath the fiber
unit to allow adequate ventilation.
As your camera will often be used on a tripod, or shoulder mounted, clearance will
already be provided. However, if you are operating the unit sitting flat on a surface it is
a good idea to attach the URSA Mini shoulder mount pad, or third party baseplate or
bridge plate as this will maintain the cooling fan's air flow in the underside of the
Fiber Converter.
6
Use the included BNC cables to connect the
SDI output on the back of your camera to
the SDI input on Blackmagic Camera Fiber
Converter, and the SDI output from the fiber
converter to the SDI input on the rear of your
camera.
Getting Started with Blackmagic Fiber Converters 184