Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 194

or URSA Broadcast are on channels 1 and 2 by default. Line or Mic level XLR inputs that
are plugged into the Camera Fiber Converter are mapped to channels 3 and 4 by
default. You can adjust the output channel settings to change these mappings from
their default settings. If either of the XLR inputs on the Camera Fiber Converter are set
to AES, this expands your channel mapping options to include channel 5 and 6, which
are sent on your embedded SDI output.
Mapping the embedded XLR channels from the camera to output channel 1 and 2
Talkback
Use the 'talkback' menu to select your program audio source and talkback source for
the production and engineering channel. Set the talkback source to 'SDI + DB25' or
'intercom tally DB25' on your Studio Fiber Converter.
You can also adjust the 'headphone gain' and 'headset microphone gain' for each
intercom headset to account for the impedance levels of the headsets. The 'phantom
power' settings let you switch on the phantom power being sent to the respective
headset. Adjust the 'sidetone level' settings to let camera operators hear their own
voice in their headset at a clear and comfortable level.
The intercom section will be greyed out when nothing is connected to the
XLR inputs and will display 'connecting' during connection
Operating the Studio Fiber Converter 194