Studio Unit Connections; 12G-Sdi Output; Return Sdi Inputs - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

Studio Unit Connections

The rear panel of the Blackmagic Studio Fiber Converter provide SDI return feed and reference
BNC connectors, intercom and tally DB-25 connector, PTZ 9 pin serial port, audio outputs, and
Ethernet.
All SDI inputs support 12G-SDI for video formats up to Ultra HD 2160p60.

12G-SDI Output

The two 12G-SDI outputs are for connecting the camera signal from the studio unit to any of
your switcher's camera SDI inputs. The second connector can be used to output the same
signal to other video equipment, for example a Blackmagic Videohub router, SmartView monitor
or a HyperDeck Disk Recorder.
12G DIGITAL I/O
RETURN IN
1
The 12G-SDI outputs allow for signals
from 720p50 up to 2160p60

Return SDI Inputs

The 12G-SDI return feed BNC connectors give you the option to plug in up to three return
SDI feeds. For example, the program feed from a switcher should be connected to return 1 and
have a matched frame rate to that of your camera. Other sources like a second camera output,
HyperDeck playback, or even a teleprompter can be connected to return feeds 2 and 3. If you
are using an ATEM switcher, the program return connected to return 1 will also include tally,
talkback, reference and camera control signals.
The return SDI inputs allow you to connect up to three return feeds from your switcher. These
feeds will be fed to your camera so that they can be viewed by the camera operator, or fed out
via SDI to other equipment.
OUT
2 3
Studio Unit Connections 204