Blackmagic Ursa Mini Pro Pl Mount - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

Blackmagic URSA Mini Pro PL Mount

Attaching the PL mount to your URSA Mini Pro lets you use high end precision cinema lenses
for feature film and television production.
The PL mount kit includes:
Tools Required
When attaching the PL mount, you will need a 2mm Hex driver. While it's not absolutely
required, we recommend using a torque wrench able to accurately set a maximum torque
of 0.45Nm to reduce the potential of over tightening the screws.
2mm Hex driver
1 x PL mount
The PL mount is shipped with a protective dust cap.
1 x Shim set
The shim set includes the following thicknesses:
0.50mm 0.18mm
0.30mm 0.15mm
0.20mm 0.12mm
1 x PL baffle
The PL mount baffle helps to control and direct the light entering
the sensor.
1 x Baffle tool
Use the PL baffle tool to tighten the baffle in your camera.
5 x 2mm Hex M2.5 x 22mm mount screws
The five M2.5 x 22mm Hex screws are exclusive to the PL mount
so you can keep the screws together with the respective mount.
The PL mount kit also comes with a full spare sets of screws in
case the originals are misplaced.
0.10mm
0.05mm
0.025mm
Interchangeable Lens Mount 211