Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 141

Good take
Tap the 'good take' indicator to flag good takes for easy recall in post production. This tag
applies to either the last clip recorded, if your URSA Mini is in standby mode, or the clip
currently being viewed in playback mode.
Int / Ext
Tap 'int' or 'ext' to add a 'interior' or 'exterior' tag to the next clip in standby mode, or the current
clip in playback mode.
Day / Night
Tap the 'day' or 'night' icons to add a 'day' or 'night' tag to the next clip in standby mode, or the
current clip in playback mode.
'Project' Metadata
Project metadata behaves the same way whether you are in standby or playback mode.
This metadata always refers to your project as a whole and is independent of clip numbers.
Your URSA Mini's 'project' slate tab
Project name
Displays your current project name. Tap the pencil icon to change the project name.
Director
Displays the director's name for the current project. Tap the pencil icon to change
the director name.
Camera
Displays a single letter camera index. Tap the pencil icon to change the camera index.
NOTE Camera index is used in metadata and for file naming purposes and differs
from your URSA Mini's ATEM Camera ID, which is used when controlling your
URSA Mini with an ATEM switcher. For more information on ATEM Camera ID, see the
'Understanding Studio Camera Control' section in this manual.
Camera Op
Displays the camera operator. Tap the pencil icon to change the camera operator name.
Entering Metadata 141